Q:Motor has been running then fails to start,what to do? A:Likely cause: Fuse or circuit breaker is tripped.
What to do: Replace the fuse or reset the breaker.
Likely cause: Armature is shorted. Motor may make a humming noise and the circuit breaker or fuse will trip. What to do: Disassemble motor and inspect the armature for a burnt coil. Inspect the commutator for burnt bars. If this condition exists, the motor needs to be replaced.
Likely cause: The brushes may be worn down too far and no longer make contact with the commutator. What to do: Check the brushes to make sure that they are still making contact with the commutator. Contact manufacturer for brushes.
Likely cause: Controller may be defective. What to do: Verify voltage is coming out of the controller.
Q: On initial installation, motor fails to start up,what to do? A: Likely cause: Motor is incorrectly wired What to do: Verify that the motor is wired correctly.
Likely cause: No output power from controller. What to do: Measure voltage coming from the controller.
Likely cause: Motor is damaged and the armature is rubbing against the magnets. What to do: Disassemble motor and see if the armature can be realigned by reassembly. Motor may have to be replaced.
Q: Motor takes too long to accelerate,what to do? A: Likely cause: Motor controller not properly set. What to do: Adjust the acceleration trim pot of the controller.
Likely cause: Brushes are worn. What to do: Verify brush length.
Likely cause: Bearings may be defective. What to do: Inspect bearings. Noisy or rough bearings should be replaced.
Q: Motor runs in the wrong direction,what to do? A: Likely cause: Incorrect wiring What to do: Interchange the two motor leads.
Q: Motor runs OK but has a clicking noise,what to do? A: Likely cause: Suspect a burr on the commutator. What to do: Remove burr from commutator using a commutator stone.
