100ct DC12V WS2811 bullet led pixel с разъемом Ray wu 13

1) Individually addressable flexible RGB WS2812B LEDs matrix.

2) There are 3 size : 8x8cm,  8x32cm, 16x16cm.

3) Each matrix with one pair JST SM connector for controller signal transmission and extra two wires for power feeding.

4) 24-bit color control (8-bit PWM per channel ).

5) SPI control interface

6) DC 5V operating voltage

7) Each RGB led draws approximately 80mA at 5V with red, green, blue and white at full brightness.

8) 10mm spacing between LED centers.

9) Power /date connectors for easy chaining, and additional power and ground wires for alternate power connectors.

10) Controller: SD card controller, DMX controller, ardunio and so on.

Advantage:

1. The WS2811 SMD5050 RGB LED,  every led built-in(embedded) a WS2811 IC,, therefore every one led lighting effect can be controlled, every RGB led is digital addressable.

2. Every one LED lamp can be arbitrary cut-off, good flexibility, easy installation, can be arbitrary bending.

Features:

1- The Pixel WS2812B flexible LED matrix is a great way to add an impressive amount of color while still being able to individually control each LED.

2- 256 individually addressable LEDs on the flexible panel.

3- You can create animations, games, or even incorporate them into a fun e-textiles project. On top of all that, thanks to its flexible backing, this LED Matrix can be bent and bowed to fit onto almost any curvy surface.

4- These panels require a 5V low voltage input for power which needs to be able to source a good amount of current–up to 5A in most uses (5A if all LEDs are set to bright white, which is NOT recommended).

5- Attached to each flexible LED matrix are two 3-pin JST SM connectors and two sets of bare power cables(input/output), which provide you connections for DC5V+, COM-, DAT, and GND. Needless to say, if you are looking for a large panel of addressable LEDs to fit the contours of almost any surface you`ve come to the right place.

6- Note: Repeated / Over bending may significantly reduce the structural integrity of the flexible panel. It is advisable when bending it over curved surfaces to not be too rough with this product as you may damage LED traces or the panel itself.