Вилочный погрузчик генератор 12 в 24 В 200 ач автоматическое зарядное устройство 110 постоянного

1.\tThis product is applicable to the 12V or 24V lead acid batteries,including added-water storage batteries ,starting batteries and maintenance-free batteries.
2.\tIt uses the advanced microcomputer managemental system to multi-protect your batteries.
3.\tIt uses the pulse width modulation(PWM) technology to automatically charge the batteries through a 4-stage charging cycle.
4.\tGuarantee that the batteries won’t damage even if the batteries sulfided, storaged gas,or lost water.
Specification:
1.\tThis device is widely used in 12V or 24V batteries (6AH-200AH).
2.\tUse the advanced pulse width modeling technologies, full microcomputer controlled charging modulation to display ,constant currents, constant ,voltage ,trickle, floating charge.
3.\tThe microcomputer digital pulse to repair can immensely increase the lifespan of your batteries.
4.\tUse the advanced microcomputer management system to multi-protect the batteries.
5.\tModule: motorcycle ,automobile charging modulation.
6.\tTo motorcycle is used in charging 6AH to 20AH, to automobile is used in charging 20AH to 200AH.
The Specification About The Charging Mode:
A.\tThe Charging Mode For Motorcycle:When turn on to charging your battery, the indicator will be a long light. When full-charged ,the indicator light will be extinguished. On this load ,the system will be on a maintenance mode automatically. The charger is suitable to charge 6AH to 20AH batteries for motorcycle.
B.\tThe Charging Mode For Car: When turn on to charging your battery, the indicator will be a long light. When full-charged ,the indicator light will be extinguished. On this load ,the system will be on a maintenance mode automatically. The charger is suitable to charge 20AH to 150AH batteries for car.
The Functional Description:
When the charging rate displays 25%、50%、75%、100% ,it shows the charging rate of power.This product use the full-microcomputer screen display, smart pulse charge. Pulse charge normally use the solution which is both charging and releasing that charged for 5 seconds then released for 1 seconds ,therefore the most Oxygen which was produced from the charged procedure will become the electrolyte on the pulse way. Not only limit the gasification what inside electrolyte of your battery ,but also can repair your battery which sulfided.

The Working Mode:
Constant Voltage:Use the constant voltage to charge batteries,whether the current will start largely,but as it is working will decrease less.
Constant Current:It means the storage battery voltage is lower than the set voltage of this charger, but this charger will supply constant charging current to your batteries so that it can maintenance both the battery and the battery charger.
Trickle Charge Modulation:When the battery voltage is approaching the set voltage and the charging current is lowing to the set current,it will turn to the floating charge mode from trickle charge mode automatically,it means full-charge,but it will keep on floating charge mode.
Floating Charge Modulation:It will keep maintenance-method charging your battery ,but the charging current will be small a bit.
Multi-protection:
Overheating protection:When the temperature of the charger is over 150℃ ,our charger will stop working ,when the temperature reduce to 80℃ or turn off the power ,after 10 minutes,the charger can work again.
Short-circuit protection:When the charger output has short-circuit and automatical stop working will have the long beep alertness. Just connect it exactly, it will be automatically recharging again .
Reverse-connecting protection:When you put the reverse-connection,the charger will automatically close the output and alarm with the long beeps, after exactly to connet it will be automatically recharging again.