13L настенный газовый водонагреватель без резервуара для

Taiwan JTL was ISO 9001 certified and have achieved MIT smile mark quality certification and Good Design award nationally.

Actions of the factory obtain international quality certification ISO 9001, the production of each product works based on SOP implementation, holding the establishment of the plant bright and tidy, and the overall planning principles: U-type production line to increase liquidity, grow production efficiency, design EPOXY Board dust, obstruction, ensure a good working environment for staff, and improve the quality of the factory.

Each section of the production line relied on SOP standard process; to seize the JTL most concerned about is that all products must be high quality.

QA (Quality Assurance) is the most important part of the work. Plant inspection (First Article Inspection), before leaving the factory to do a full inspection (Full Check), strict management of product quality: plant inspection work is according to CNS national standards.

Each gas furnace must check the switch, with a flame to test the flame of the gas furnace to ensure that the product to the consumer's hand has been 100% inspection to ensure that consumers use the security.

For household electrical appliances, all use the safety equipment in a regular check the voltage, ground wire. Before leaving the factory verify the safety of the product.

The establishment of laboratories, combined with the use of sophisticated machine simulation, strict inspection of the factory products.

JTL division of labor to research and technical personnel R&D design unique products. Since 2004, the establishment of a laboratory test gas furnace, electrical room. With the use of precision machinery such as: analysis of exhaust, CNS test, gas consumption, through the establishment of high temperature and high temperature, supervision of electronic IC products to capture, capture and edit possible problems in the future as a key design basis for structural design. In addition, more closely check the pressure, wear, vibration, open. In order to make the product in the factory before the quality assurance.