Инструменты для ручной настройки страз аппликатор горячей фиксации Стразы 100-240

Описание и отзывы

Трекер стоимости

Характеристики

Rhinestone manual setting tools hotfix strasssteine applikator, 100v-240v hot fix applicator

 

Related words: hot fix gun ,hot fix pen ,hot fix rhinestone gun ,hot fix rhinestone applicator ,rhinestone applicador , rhinestone welding gun ,strasssteine applikator,rhinestone applicating gun , rhinestone machine , rhinestone tool, strass wand applicator, hot fix tools, hot fix applicator,hot fix manual machine

Preparation

i. You will need a firm surface to work on such as a table top or work surface; ironing boards aren’t suitable as they don’t provide enough support.

ii. If adding crystals to fabric make sure that the materials surface is flat, iron if necessary.

iii. When adding crystals to sheer fabric its best to place a piece of card or a Teflon sheet between the layers to prevent the glue from seeping through and bonding any fabric layers together.

iv. You will also need a pair of fine tipped tweezers.

v. If it’s your first time using a hotfix applicator its a good idea to first test on a piece of card or scrap material.

1. Choose the correct size applicator tip for the rhinestone size you will be working with, the sizes are etched into the side of a tip.

 

2. The applicator tip fits on the end of the hotfix applicator, gently screw the correct size applicator tip into place.

 

SAFETY: Make sure the hotfix applicator is unplugged and if you are removing a tip it has already had plenty of time to cool down.

3. Turn on the hotfix rhinestone applicator,  Crystal Ace Professional hotfix applicator has an on/off switch at the rear. Other applicator wands will only need plugging in as there is no on/off switch. ( hotfix applicator will take approximately 3-5 minutes to reach working temperature) Lay the applicator on the work surface with the tip pointing away from your working area so that you do not burn your hand as it heats.

 

4. Place your hotfix crystals onto a clean flat, solid surface. (placing them onto a piece of white card can be helpful if you are working on a dark surface)

 

5. Turn all the crystals so that they are facing faceted side up. 

Applying the crystals

 

6. When the crystal comes out of the tip the adhesive is very hot, so give the crystal a few seconds to cool then gently pull on the crystal to see if the glue has bonded to the surface correctly. If the crystal is still loose place the tip over the crystal for a few seconds to melt the glue and then test again once the adhesive has cooled to ensure that the crystal is firmly bonded to the fabric..

 

Enjoy shopping with us and always feel free to contact us for any help!

 

 

OEM packing example

( we can also make OEM packages, below is an example)