Цифровой спутниковый Finder метр LNB цифрового ТВ-сигнала Satfinder для найти выравнивание сигнал приемное

Wiring and Operation
Connect a jumper cable from the LNB/LNBF to the “TO LNB connectionon the Satellite Finder.
Connect the cable from your satellite receiver to the “TO REC" input onthe Satellite Finder.
Make sure youer satellite receiver is on. The Satellite Finder's scale should be lighted at this time and the meter readng should be around 2.
Set your dish to the proper azimuth and elevation settings.(This information should be supplied with your dish.)
Set the Satellite Finder's scale reading to about 5 by adjusting the level control found on the face of the Satellite Finder.(Turning the knob clock wise will increase the reading.)
Peak the signal by slowly moving the azimuth and elevation of your dish.If the Satellite Finder's reading becomes full scale, adjust the level controknob to reduce the reading to around5.(Turning the knob counterclockwise will decrease the reading.) Continue to move the dish until you have the highest possible meter reading.
Remove the jumper cable and Satellite Finder and reconnect the LNB/LNBF to your receiver.

Important Notes

 To avoid a continuous full scale reading, do not use the Satellite Finder directly in front of the dish.

When using a LNB/LNBF with gain higher the 60 dB, insert a 5 dB attenuator between the LNB/LNBF and the Satellite Finder.