Эпоксидный отвердитель E51 2:1 AB клей с высоким блеском легко проникает под руку сделай сам углеродное волокно поверхность ткани

Описание и отзывы

Трекер стоимости

Характеристики

Product Features:

\t
1. 
   \t

   This product is easy to operate, and the foam is easily disappeared after stirring. High transparency after curing, high gloss, no bubbles, and pits.

   
   \t

\t
2. 
   \t

   various carbon fiber fabric manual DIY, marble, wood, metal solar panels，Crystal handicraft production Surface coverage protection

   
   \t

Application method：

\t
• 
  \t

  Strictly according to the weight ratio of A: B = 2:1 for reconciling, the proportion can also be adjusted according to the actual situation.

  
  \t

\t
• 
  \t

  Stir slowly and thoroughly, then it needs to stand for 2-5 minutes before using, so as to control the generation of bubbles.

  
  \t

\t
• 
  \t

  Please run out of sth it within 20 minutes under normal temperature (25℃).

  
  \t

\t
• 
  \t

  Attention Please

  
  \t

①. Due to the high temperature in summer, the waiting time will be shortened after mixing. It can be used after standing for about 2 minutes.

\t
• 
  \t

  ②. The temperature is low in winter, the viscosity of the resin will increase.

  
  \t

\t
• 
  \t

  A glue can be preheated properly to reduce the viscosity and then proportioning.

  
  \t

Cautions:

\t
• 
  \t

  It is not suitable to mix too much glue at a time, using it immediately when mixing well. The higher the temperature is, the shorter the application period is;On the contrary, the longer.

  
  \t

\t
• 
  \t

  After the resin perfusion is done, if the resin layer is found to have bubbles, use a fine needle to break the bubble, the bubble will automatically rise. During the operation, please keep the environment clean and prevent dust pollution products.

  
  \t

\t
• 
  \t

  mixed glue during curing, the curing agent will absorb the moisture, when the air humidity is large, the surface of the cured surface will have a layer of oil. Therefore, it is kept dry during the curing, and do not cure in a large environment of humidity. When there is an oily, the surface can be dried, and then the sandpaper is polished.

  
  \t

\t
• 
  \t

  when the temperature is less than 15 degrees, the resin will have a crystalline phenomenon, which will become a haze, flocculation, and solidification into a white solid. When used, the resin can be warmed, the temperature is high, and resin When the opening is transparent, it is used again and does not affect the curing performance.

  
  \t

\t
• 
  \t

  Use alcohol to clean the excess glue on the hand or the stickies before curing.  In case of contact with skin, rinse with clean water. If it is serious, see a doctor.

  
  \t

\t
• 
  \t

  Cover tightly after using, do not mix covers.

  
  \t

\t
• 
  \t

  Keep out of the reach of children, do not enter the mouth!

  
  \t

\t
• 
  \t

  Before using this product, please try it in advance to avoid mistakes!

  
  \t