Сварочное оборудование для горнодобывающего проекта в

Описание и отзывы

Трекер стоимости

Характеристики

Welding Equipment for Mining Project in Malaysia

1.Basic parameter:

 

Voltage:	230V
Frequency:	50/60Hz
Power:	800W
Welding speed:	0.5˜5m/min
Heating temperature:	0-450°C
Thickness of material:	0.2mm˜1.5mm
Overlap width:	10cm
Welding width:	12.5mm×2, interior cavity 12mm
Seam strength:	≥85% base material (tensile resistant  in shear direction)
Weight:	5kg
Insulation class:	class II

 

 

 

2.Accessories: 

 

Including control box,hot wedge,silica gel roller,steel roller.

 

3.Packing:

 

 

 

4..Operation:

 

5.Application:

 

Application covers refuse landfill anti-seepage project, sewage disposal anti-seepage project,

 

lake anti-seepage project, water conservancy anti-seepage project, tunnel anti-seepage project,

 

minerals place anti-seepage project, cultivation pond anti-seepage project, roofing waterproofing

 

 project etc.

 

 

 

Readiness of working:

 

• Fit appropriate nozzle as required


• Connect tool to the line/mains


• Adjust air temperature


• Switch on main switch and heat up the tool for approximately 5 minutes.

 

Changeable nozzles:

 

• Do not touch the hot nozzle and make sure to place it on a heat resistant surface because of the fire hazard..


• Put the nozzle on the heater tube and secure the nozzle by the screw on the cap.


• Use nozzles only.

 

Maintenance:

 

• Clean polluted air filter with a small brush or replace it


• Clean welding nozzle with a steel brush.


• Check mains cable and plug for electrical and mechanical damage.

 

Service and repairs:

 

• The motor switches off automatically when the brush reach their minimum length. Have the tool checked by your service center. The life of the brushes is about 800 hours.


• Repairs should be carried out by authorized service centers only. They guarantee a specialized and reliable service.


• Sorry for not special notice in advance if there would be changes on parameters.

Warning

 

• Unplug the tools before opening it.


• Incorrect use of hot-air blowers can cause fire and explosion hazardous especially near combustible materials and explosive gases


• Do not touch heater tube and nozzle when they are hot. They may cause burns. Do not point hot air flow in the direction of people or animals.  

Caution:

• The voltage rating stated on the tool must correspond to line/mains voltage.


• For personal protecting on the building site, we strongly recommend the tool be connected to a GFCI(Ground Fault Circuit Interrupter)or a RCCB (Residual Current Circuit Breaker)


• The tool much be operated with supervision. Heat can reach combustible materials which are out of sight.

Our service:

With years experience in foreign trade, our sales are professional and careful, easygoing and trusted,dedicated and skillful.We will try our best to meet any needs of any customer.Trust us and you will enjoy a friendly and happy trading.

 

Trading Process: