Гильотинные ножницы для резки с наконечником Forever

1. Material: 9CrSi, SKD-11,6CrW2Si,Cr12MOV, H13. Special Tool steel

2. Hardness:HRC50-63 for could shears,HRC45-63 for hot shears

3. High precision surface,burr-free

4. Retangular section upper and lower blades, 4 edges to use

5. Strict quality management system

6. Small orders accepted.

7. OEM and ODM

Bade bear high hardness, good resistence to wear, as well as reliable quality and complete variety, meeting your requirements.

Steel-choosing→Blanking →Forging Steel →Rough Processing →Heat treatment →Finishing→Testing

Steel-making by medium frequency furnace

Nanxia  company can meet special requirements for materials. In order to guarantee the qualit, the company imported the spectrometer from Germany and is equipped with various testers, such as tensile tester, impact testing machine, metallography analyzer and so on.

Electro slag remelting

The largest ingot can reach 3 tons in the company. The ingot obtained by this remelting/refining process is very homogeneous and free of internal defects. The segregation of the ingot (called macro-segregations ) are substantially eliminated and the segregations of crystals (called macro-segregations ) are significantly reduced.

The ESR remelted material improve following mechanical characteristics:

Improved toughness due to increased homogeneity and isotropy
Improved creep resistance properties
Best fatigue strength and tenacity properties as well as outstanding tensile strength
Improved purity

Forging steel

The largest electro-hydraulic hammer is 4.5 ton. And more than 6 skilled technicians work for us. After forging, the inside

microstructure becomes much closer and the metal grain size becomes much smaller. It can evevate the characteristics and quality of the knife ensuring a longer life.

Rough processing

No less than 40sets of processing equipment in the rough processing workshop of the  company, including lathe ,milling machine, planer, drill machine etc. Skilled workers are employed in its rough processing workshop.

Heat treatment

Nanxia  company has independent workshop for heat treatment. Couples of skilled technicians work here. Actually, most blades ( thickness ≤100mm) can be fully hardened. Thus, the blades can be used after repairing until the size reached the minimum design dimension.

Finishing

Nanxia  company has more than 35 sets of processing equipment including internal grinder, external grinder, surface grinder, CNC grinder, electric spark CNC wire-cut etc. The company can produce the shearing blades with 5500mm in length and slitting knives with 1500mm in outside diameter.

Testing

Various testers are put to use for testing its products in Nanxia