Xhnotion холодный воздух пистолет шкаф охлаждения

8.Uses only filtered compressed air – no Freon required ( no CFCs/HCFCs).

1.The cold air gun is connected to the magnetic base.
2.Cold air touch to connect the universal tube Flexible hose.
3.The inlet of the compressed air is connected to a gas source with a pressure of 4-9 Bar.
4.The on/off of the cold air gun is controlled by the opening and closing of the ball valve on the base.
PT1/8 is a window for adjusting the amount of cooling. First unscrew the PT1/8 screw off, then use a slot screwdriver to rotate clockwise to increase the cooling capacity, and vice versa. (The valve rotates two times, the ratio of hot and cold air is about 50:50)

Note: Don’t screw the adjustment screw! Otherwise, it cannot achieve cooling effect.

TROUBLESHOOTING & MAINTENANCE 

If The Cold Gun Does not Perform Properly, check for these common problems

1.Inlet Pressure -Low inlet pressure supply will cause poor performance. (standard pressure of the cooling gun is 6.9 Bar), Usually compressed air does not use only one tool or device, so the pressure and flow rate of the terminal will be reduced.
2.The inner diameter of the compressed air pipe is not large enough, resulting in low pressure supply.

3.The internal diameters of various fittings of compressed air are smaller than the internal diameter of the pipes, so the pressure will lost in many places and the flow rate will be reduced.

4.Pipes or fittings are leaky

5. Inlet Temperature -A Cold Gun provides a temperature drop from supply air temperature. In some cases, the supply air is warmer than ambient air due to compressed air lines running across ceilings, near furnaces, direct sun, etc. In this case, the cold air may be warmer than anticipated and adequate refrigeration may not be available for the application.

6. Back Pressure - The performance of a Cold Gun deteriorates with back pressure on the cold end exhaust. Use only the flexible segmented hose included with the Cold Gun System.

7. No Cold Flow - If the filter is not drained regularly, water may overflow into the Cold Gun and cause internal freezing. This can reduce or even stop cold air flow. Drain the filter often, or crack open for a small continuous air bleed. If internal freezing occurs, any one of the following will correct the problem:

SOLUTION.

1.Please increase the supply of compressed air.
2.For the compressed air input hose, please use 10-12 mm. If you use a suitable fittings, it will increase

the flow of compressed air.
3.Please check whether the pipe system is leaking.

4.Blow air (use an air gun) into the cold muffler with the Cold Gun off.

5. Turn the Cold Gun off for a few minutes.

6. Put a dryer on the compressed air supply.

Note:

1.The high temperature of the hot air end is normal, but please take care to prevent accidents.
When the hot air has not been discharged, part of the heat has been transferred to the vortex tube, so the temperature is not high after being discharged from the gun body, and it does not harm to the human body.

Packing Details : A) Blow molded sturdy tool kit 

                                 B) neutral carton box

                                 C)Custom packaging are available, XHnotion brand packaging are available

Delivery Details : 3 days to 30 days depends on actual orders.

    XHnotion, is a leading manufacturer of pneumatic components and flow valve in China. Our products include below items pneumatic fittings, plastic, brass, stainless steel push in fittings pneumatic quick coupling, air tool kits, air blow gun pneumatic muffler, silencer, filter air hose- PU tubes, nylon tube, PE tube, PTFE tubes, etc

     Solenoid control valve for water, air, diesel, oil, air cylinder, air preparation, pneumatic directional valve modular hose, water push in fitting. 

 Factory

Workshop