Соединительный кабель LMR240 с обжимным коннектором «папа» N и DIN

Discription:

 Jumper Cable of different connector series can be assembled as either straight or angle versions by using the corresponding clamps.With only one combination connector and the different cable clamps,a variety of connectors can be produced allowing a reduction in stock-levels.The technical specifications can be obtained from the descriptions in the respective chapters for each series.

Note: connector and cable type,length an be changed based on customer's requirements.

Applications: 
Antennas/ Base station /Broad cast /Cable assembly /Cellular /Components /Instrumentation/Microwave Radio/Mil-Aero 
PCS/Radar /Radios/Satcom /Surge protection WLAN
Note:
1) These characteristics are typical but may not apply to all connectors
2) OEM and ODM are available

LMR240 jumper cable with N male crimp connector and DIN male crimp connector 20cm

Pictures:

Interface

According  to: IEC60169-16/IEC60169-4

Electrical

1.Characteristic Impedance:50ohm

2.Frequency Range:DC-3GHz

3.VSWR:≤1.15

4.PIM:≤-155dBc

5.Dielectric withstanding voltage:≥2500RMS,50Hz,at sea level

6.Dielectric Resistance:≥5000MΩ

7.Contact Resistance:Outer Contact≤0.5mΩ ;Center Contact≤1.0mΩ

Mechanical

1.Durability :Mating cycles ≥500

2.Material and plating:

Body Material: Brass  Plating: Tri-alloy

Insulator Material: PTFE

Center Conductor Material:Brass /Phosphor Bronze Plating: Ag

Environmental

1.Temperature Range:-40℃~+85℃

2.RoHS Compliant: Pass

Note:

All products appearance, technical performance and electroplating can be customized according to your requirements.

 Packing can be customized by customers' different requirements.